Wall Mounting - Dimplex Monterey MFP050 Installation And Operating Instructions

General
The heater is designed for wall mounting on the wall bracket
supplied. It should only be operated when in the upright
position as shown - see Fig. 1.
All models are splashproof to IPX4 standard and may be
used in bathrooms, however not in the immediate vicinity of
baths, showers, water connections, wash basins or
swimming pools.
Before connecting the heater check that the supply voltage is
the same as that stated on the heater.

Wall Mounting

IMPORTANT – The wall bracket supplied with the appliance
must be used. The heater should be positioned observing
the minimum clearances stated around the heater - see
Fig. 1.
DO NOT locate the heater immediately below a fixed socket
outlet or connection box.
1. Remove wall mounting bracket from the back of the
heater by depressing the spring latch at the top of
each bracket - see Fig. 2.
2. Fix the wall bracket securely to the wall through the
four screw holes provided.
3. Present the heater to the wall bracket, and engage
lower slots in the back with bracket.
4. Raise the heater to upright position and push the
heater onto bracket to engage top latch.
C D
MFP500 390 300
MFP750 390 300
MFP1000 560 300
MFP1500 630 300
MFP2000 800 300
Operation
Switching On the Heater (see Fig. 3)
The controls are located on the right hand side on top of the
appliance, lift flap to access the controls - see Fig. 3.
The button marked ' ' controls the electricity supply to the
electronic thermostat. An indicator beside the ' ' button
shows when the unit is powered 'ON'.
C
D
255 Min.
Fig. 2
Fig. 3
*
Setting Desired Temperature (see Fig. 4)
The heater is fitted with an adjustable thermostat enabling
the room temperature to be controlled by adjusting the slider
accordingly. The min setting '
temperature of approximately 5
protection against frost. The 'MAX' setting represents a room
temperature of approximately 30
when the elements are actually heating.
Turn on the heater using the ' ' button and move the
thermostat slider to the desired position. When the room
temperature has reached the desired level, the power to the
elements will be reduced, the heater will then maintain the
room temperature at the chosen level.
NOTE - Should your heater fail to come on when the
thermostat slider is at a low setting, this may be due to the
room temperature being higher than the thermostat setting.
Background Temperature
When used in conjunction with a remote programming device
supporting a background/setback setting, the heater will
automatically operate at a room temperature setting of 5
less than the thermostat setting when the programme is in
background/setback mode.
Limiting the thermostat setting
Before wall mounting the product the installer may wish to
limit the heat selection slider movement for the operator.
This may be achieved by removing the two plastic pins (see
'x' in Fig. 5) from the rear of the thermostat moulding using
pliers and inserting them in the preferred holes to limit the
slider movement.
MAX
Fig. 4
' represents a room
0
C and may be used for
0 C. The ' ' symbol glows
'x'
Fig. 5
0
C