Bose FreeSpace DS 100SE Owner's Manual page 24

Hide thumbs Also See for FreeSpace DS 100SE:

US-ONLY • KUN USA • NUR USA • SÓLO EE UU • ÉTATS-UNIS UNIQUEMENT • SOLO USA • ALLEEN VS • ENDAST USA

With standard steel 4" x 4"

junction box

The FreeSpace

DS 100SE loudspeaker can be mounted directly on

standard U.S. steel 4" x 4" junction boxes. There may be several

junction boxes available that are compatible with the FreeSpace DS

100SE wall mount bracket, but Bose Corporation only recommends

the junction boxes it has validated.

U.S. 4" x 4" Standard Steel Junction Boxes

Approved by Bose

Manufacturer:

Steel City

Catalog Number

52151-1/2 & 3/4-EW

Please check pro.Bose.com for an up-to-date list of

Bose

validated junction boxes.

Mounting the Bracket

Manufacturer:

Raco

232

8232

• It is the responsibility of the installer to properly install junction

boxes to ensure the safety of the loudspeaker installation.

Consult a building professional for the proper junction box

installation methods before installing the loudspeaker.

• The junction box should be installed in such a way that it is

structurally capable of supporting the weight of the loudspeaker.

A 10:1 safety weight ratio is recommended.

• Failure to properly install a junction box or loudspeaker could

result in damage, injury, or death.

When installing the FreeSpace DS 100SE loudspeaker on a Bose-

validated on-wall junction box, only two (2) of the four (4) screw holes

of the wall mount bracket will be used. Bose has conducted

extensive tests to ensure that this loudspeaker mounting scheme

results in a safe installation. This loudspeaker mounting scheme has

passed a 10:1 safety weight ratio test.

• Use #8-32 x ¾ screws with #8 washers or #8-32 x ¾ truss head

screws to mount the bracket to the junction box.