Table of Contents
Advertisement
CAUTION:
Ensure that the proper pin is selected for AC operation. Applying power on the
wrong pin may permanently damage the SSPB, necessitating factory repair.
d. Connect the AC power cable to AC Line port of the SSPB and the AC power source.
Power Requirements
Power Consumption
TABLE 10: AC LINE (J5) CONNECTOR – PIN ASSIGNMENTS
5.3.4 RF C
ONNECTIONS
CAUTION:
Beware of the destructive pin depth of the mating connector. When installing an
RF mating connector with a destructive pin depth into an RF component connector, damage
may occur to the RF component connector. A destructive pin depth is a connector having a pin
length that is too long in respect to the reference plane of the connector. The centre pins of the
connectors used by ADVANTECH have a precision tolerance measured in mils (1/1000 inch).
The mating connectors of the various suppliers may not be of precision types. Consequently,
the centre pins of these devices may not have the proper depth.
1. Attach the interconnecting cable with a N-type male connector from the RF source on to the L-
Band IN connector (J1) located on the rear panel (see Figure 5 at page 24).
2. If necessary, connect a power meter or a spectral analyser to the RF output monitor port
located on the front panel (see Figure 5 at page 24).
TABLE 9: POWER REQUIREMENTS
Pin
A
B
C
180 - 264 VAC, 47-63 Hz, single phase
8 A typical @ 230 VAC
Description
PHASE (LIVE)
GROUND
NEUTRAL
SSBP-3000C
Page 28
Advertisement
Table of Contents
