PRE-RIDE CHECK
To check tire inflation pressure:
1.
Remove the cap from the valve on one tire, and then firmly press the tire gauge onto the
valve.
2.
Add air till you reach the recommended air pressure.
3.
Replace the valve cap.
4.
Repeat this procedure for each tire.
5.
Visually inspect the tires to make sure there are no nails or other objects embedded that
could puncture the tire and cause an air leak.
6.
Check the sidewalls to make sure there are no gouges, cuts, bulges or other irregularities.
7.
A tire inflation pressure placard is located on your scooter. This placard indicates the
designation of the factory-mounted tires on your vehicle, as well as load limits and inflation
pressure.
NOTE: The placards shown indicate inflation pressure for the tires
installed on the scooter at the factory only.
36