Amana AMV6177AAB Service Manual page 23

L. REMOVING THE TURNTABLE MOTOR
(1) Remove the turntable.
(2) Remove the turntable shaft VERY CAREFULLY
with a slotted screwdriver. (Figure 21)
(3) Remove the base plate by removing 7 screws
securing it to the oven cavity. (Figure 22-a)
(4) Disconnect the leadwire from the turntable motor
terminals.
(5) Remove the 2 screws securing the turntable motor
to the oven cavity ASS'Y. (Figure 22-b)
Figure 20
Figure 21-a
Wire Leads
Figure 22-b
NOTES:
• Remove the leadwire from the turntable motor
VERY CAREFULLY.
• Be sure to grasp the connector not the wires when
removing.
Turntable Motor
M. REMOVING CONVECTION HEATER
AND THERMISTOR (Figure 23)
(1) Remove the out case.
(2) Remove the air duct by removing six screws
securing it to the oven front plate, guide air and
glasswool-L cover.
(3) Disconnect the wire leads of air duct.
(4) Remove the magnetron.
(5) Remove the latch board assembly.
(6) Remove the bottom plate by removing four screws.
(7) Remove the four net screws securing chamber
assembly.
(8) Lift the chamber assembly from the oven cavity.
(9) Remove three screws securing the heater of the
chamber assembly.
(10) Lift the convection heater from the chamber
assembly.
7-11
Figure 23