Table of Contents
Advertisement
Operation
Initial Operation
This section provides basic instructions on the use of your Air Purifier. After following
these initial directions, please continue reading this booklet to learn how to operate
the more advanced features of your Air Purifier.
Basic Operation of the Air Purifier:
1. Take the Air Purifier out of the box and remove the clear plastic protec-
tive bag. Place the unit on a firm level floor.
2. Before turning on the unit, you need to confirm that the filters are firmly
in place and have not become loose during shipping. To check the filters,
first open the Front Grill. Release the Front Grill by placing your fingers
under the handle on the Grill and pull forward, then up. Refer to Figs. 4
and 5.
HANDLE
Fig. 4
3. Next, check the HEPAtech
the Filter to ensure that it is fully inserted into the filter opening. NOTE:
THIS UNIT WILL NOT OPERATE UNLESS FILTER IS INSTALLED
CORRECTLY AND SEATED PROPERLY.
4. The Carbon Pre-Filter is mounted inside the Front Grill with hook tape.
Confirm that it properly covers the Grill vents. You may notice a few
black particles coming off the Pre-Filter. Those particles are part of the
odor-removing activated carbon and will be collected on the filter during
use.
43003-01
PULL
FORWARD,
THEN UP
Fig. 5
filter by pressing firmly on all four corners of
®
6
5. Place the Front Grill back onto the unit. First, line up the tab on the bot-
tom of the Grill with the recess on the Purifier Base and then push the
top of the Grill forward until it is closed. Refer to Figs. 6 and 7. NOTE:
THIS UNIT WILL NOT OPERATE UNLESS THE FRONT GRILL IS
INSTALLED CORRECTLY.
PURIFIER
bASE
Fig. 6
6. Plug the unit into a 120V electrical outlet and turn the Speed Knob . The
unit will start with a low blower speed.
7. Use the Speed Knob to adjust the blower speed to the desired level (Off,
Sleep, Active, Turbo Clean). Refer to Fig. 8.
SLEEP
ACTIVE
OFF
Fig. 8
7
Operation
Fig. 7
TURbO
CLEAN
43003-01
Advertisement
Table of Contents
