Using Your Total Air Sanitizer; Initial Setup And Operation - Hunter 30408 Owner's Manual

Total air sanitizer

Hide thumbs

Table Of Contents

Table of Contents

I I

1. Take the air sanitizer out of the box and remove the

clear plastic protective bag and place the unit on a

firm, level surface.

2. Before turning on the air sanitizer, you need to confirm that

the filter is firmly in place and has not become loose during

shipping. To release the door, push down on the Hunter

logo on the door to release the front grill. Figure 1.

3. Gently pull the door away from the unit and lift away.

Figure 2.

4. The HEPA

Filter will be resting inside the unit. The filter

will say "This side faces you" to indicate the direction

the filter should be placed in the unit. Ensure the filter is

seated fully into the unit by pressing all four corners of

the filter. Figure 3. In addition, the filter should be secured

with the filter bracket. Figure 4.

5. NOTE: If the filter is not seated properly inside the unit,

the air sanitizer will not operate.

6. Set the tabs on the each side of the bottom of the door into

the notches in the base of the unit and rock the door up

until the top of the door makes contact with the magnet.

7. Push the Hunter logo in until the front door "clicks" into place.

8. Plug the unit into a 120V electrical outlet.

Operation:

See Figure 5.

Low speed - Recommended for use when soft

background noise is unwanted.

Medium speed - Typical usage setting. Soft

background noise is not an issue.

High speed - Use when quick, efficient results to a

room's air quality are desired.

OFF - Press the sensor pad until all speed indicator lights are

off. This will turn the unit off.

1. The fan speed can be adjusted at any time by touching

the sensor pad on the top of the unit.

Filter Indicator - When the filter life counter exceeds 4000

hours, the filter indicator will flash red as a reminder that

you should check the filter. Touch the sensor pad for 3

seconds to reset the filter counter.