Hunter HEPAtech Plus 30760 Owner's Manual page 8

Air Purifier Maintenance
5. Carefully lift the Lamp Cover Straight up, and remove it from the unit.
Refer to Figs 12A and 12b.
Fig. 12A
6. Carefully twist the UVC Lamp until the lamp's copper prongs are visible
in the Lamp Sockets. Then, carefully remove the Lamp from the unit.
Refer to Fig. 13. NOTE: HANDLE THE UVC LAMP CAREFULLY. IT MAY
SHATTER IF IT IS DROPPED.
43003-01
Fig. 12b
LOOK FOR
LAMP'S COPPER
PRONGS
Fig. 13
14
Air Purifier Maintenance
7. Carefully remove the Lamp from the unit. Refer to Fig. 14.
Fig. 14
8. Carefully insert the new UVC Lamp's copper prongs into the Lamp
Sockets, and twist the Lamp until it is securely in place.
9. Position the Lamp Cover over the Lamp, and slide it downward until it
is sceurely in place. NOTE: THE UNIT WILL NOT OPERATE IF THE
LAMP COVER IS NOT INSTALLED CORRECTLY.
10. Install the Lamp Cover Screws.
11. Press the filter firmly into the Air Purifier. To avoid damaging the filter
media, you should press on the frame of the filter only. Refer to page
12. NOTE: THIS UNIT WILL NOT OPERATE UNLESS FILTER IS IN-
STALLED CORRECTLY AND SEATED PROPERLY.
12. Place the Front Grill back onto the unit. First, line up the tab on the bot-
tom of the Grill with the recess on the purifier base and then push the
top of the Grill forward until it is closed. Refer to Figs. 6 and 7, pg. 7.
NOTE: THIS UNIT WILL NOT OPERATE UNLESS THE FRONT GRILL
IS INSTALLED CORRECTLY.
12. Plug in the unit and turn it on. If the unit does not operate, check the
installation of the Lamp Cover and the Front Grill.
15 43003-01