Operation; Initial Operation - Hunter 30763 Owner's Manual

Operation

Initial Operation

This section provides basic instructions on the use of your Air Purifier. After following these ini-
tial directions, please continue reading this booklet to learn how to operate the more advanced
features of your Air Purifier.
Basic Operation of the Air Purifier:
1. Take the Air Purifier out of the box and remove the clear plastic protective bag. Place the unit
on a firm level floor.
2. Before turning on the unit, you need to confirm that the filters are firmly in place and have
not become loose during shipping. To check the filters, first open the Front Grill. Release the
Front Grill by placing your fingers under the handle on the Grill and pull forward, then up.
Refer to Figs. 4 and 5.
3. Next, check the HEPA® filter by pressing firmly on all four corners of the Filter to ensure that
it is fully inserted into the filter opening. NOTE: THIS UNIT WILL NOT OPERATE UNLESS
FILTER IS INSTALLED CORRECTLY AND SEATED PROPERLY.
Handle
Fig. 4
4.The Carbon Pre-Filter is mounted inside the Front Grill with hook tape. Confirm that it
properly covers the Grill vents. You may notice a few black particles coming off the Pre-Filter.
Those particles are part of the odor-removing activated carbon and will be collected on the
filter during use.
5. Place the Front Grill back onto the unit. First, line up the tab on the bottom of the Grill with
the recess on the Purifier Base and then push the top of the Grill forward until it is closed.
Refer to Figs. 6 and 7. NOTE: THIS UNIT WILL NOT OPERATE UNLESS THE FRONT
GRILL IS INSTALLED CORRECTLY.
©2008 HUNTER FAN CO.
Pull Forward,
then up
Fig. 5
6
43056-01 20081106