Advertisement
CAUTIONS
•
Read entire installation instructions carefully before beginning instal-
lation and save these instructions.
•
To reduce the risk of electrical shock, install this light fixture only on
Hunter
TM
fan types A through Z. Note: e fan type can be found on
the ceiling fan package or on the name plate label located on top of
the motor housing of the ceiling fan.
WARNINGS
•
To avoid possible electrical shock, before installing light fixtures dis-
connect power by turning off the circuit breakers both to the outlet
box and to its associated wall switch location. If you cannot lock the
circuit breakers in the off position, securely fasten a prominent warn-
ing device, such as a tag, to the service panel.
•
Connect house wiring to the fan before attaching the light fixture to
the fan.
•
All wiring must be in accordance with national and local electrical
codes. If you are unfamiliar with wiring, you should use a qualified
electrician. Professional installation is recommended.
Troubleshooting
Light does not come on.
1. Pull light pull chain one or two times to see if light comes on.
2. Make sure bulbs are installed properly and filament is not blown.
3. Make sure breakers or fuses are on.
4. Verify that the light power lead is connected at the ceiling. Refer to your
ceiling fan manual for locating assembly and wiring.
Glass rattles.
1. Securely tighten the finial.
41911-01 rev 10-13-05.indd
2
For other problems or ques-
tions, contact the Hunter Fan
Company Technical Support
at
1-888-830-1326 or
techsupport@hunterfan.com.
http://www.hunterfan.com
10/13/2005, 1:01 PM
Advertisement
