Regulatory Notices; Regulatory Agency Identifications; Federal Communication Commission Interference Statement - HTC Touch Pro2 User Manual

Section 4B

Regulatory Notices

Regulatory Agency Identifications (page 212)
Federal Communication Commission Interference Statement (page 212)
FCC Hearing-Aid Compatibility (HAC) Regulations for Wireless Devices (page 213)
SAR Information (page 214)
Body-worn Operation (page 215)
Telecommunications & Internet Association (TIA) Safety Information (page 215)
WEEE Notice (page 216)
RoHS Compliance (page 216)
This section provides more safety information and regulation statement for using your device.

Regulatory Agency Identifications

For regulatory identification purposes, your product is assigned a model number of RHOD400.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with
your RHOD400.
The Battery Pack has been assigned a model number of RHOD160.
Operating temperature range: 32°F to 104°F (0°C to 40°C)
Note This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1 Amp
power supply unit.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
212 Section 4B. Regulatory Notices