Table of Contents
Advertisement
Front Panel
SW1 (Gain / Excitation)
SW2 (Shunt Cal Switch)
SW3 (Channel Select Switch)
LED1 (Channel Select LED)
SW4 (Zero / Unzero Switch)
SW5 (Set Gain Switch)
SW6 (Set Vexc Switch)
LED2 (Power On LED)
Operating Manual Model 101, Revision 1
Sets Gain from 0.00 to 999.9 or Vexc from 0.00 to 12.00Vdc
Activates Shunt Cal Relay and Internal Shunt Cal Resistor
Used to select Channel to update
Illuminates when corresponding Channel is selected
Zeroes, Unzeroes, or Trims Zero of selected Channel
Sets Gain to Thumbwheel Switch setting of selected Channel
Sets Vexc to Thumbwheel Switch setting of selected Channel
Illuminates when V~, 50/60 Hz input power is applied
Page 9 of 14
Advertisement
Table of Contents
