Safety - Measurement Computing 101 Operating Manual

Safety

Read this manual in its entirety before operating the Model 101 Signal Conditioner. Read all wiring and power
hookup instructions and understand the requirements prior to using another manufacturer's products with the
Model 101. Insure that any product being interfaced with the Model 101 is wired according to prevailing local
safety and operational standards before operating.
The following symbols and terms may be found on the Model 101 and its manuals and indicate important
information.
When found on the device, this symbol indicates that the operator should refer to the manual
for important instructions on the proper use of this device. When found in the manual, this
symbol indicates that the reader should understand the implications contained in the text
before operating the device.
This symbol indicates that a shock hazard may be present. Read the instruction manual
carefully and insure that the device is wired properly and that all settings have been checked
prior to applying power to the device.
The WARNING label indicates important information that should be heeded for safe and proper
performance of the device.
The CAUTION label is used to indicate that damage to the power supply or equipment connected to it
could occur if directions are not followed. Warranty could be invalidated if the instructions in this manual
are not followed.
Disassembling the Instrument
Grounding
Fuse Replacement
Operating Manual Model 101, Revision 1
Turn Input Power Switch OFF before removing power cable from the instrument.
Remove power cable from instrument before disassembling any part of the instrument.
To avoid electrical shock, the power cord protective grounding conductor must be
connected to power ground.
For continued fire protection, replace fuse only with the specific type and rating by
qualified personnel (Reference Manual "Rear Panel" section). Disconnect the power
cord before replacing fuse.
Page 4 of 14