Table of Contents
Advertisement
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a with one of these parts, contact a service
technician.
To install a hot-swap power supply, complete the following steps:
1. Read the safety information that begins v and "Installation guidelines" on page
23.
2. Remove the protective power-supply cover from the back of the server.
Note: The server comes with this protective cover over both power-supply
openings.
Press in on the release tab on the outside of the cover. Move the cover off the
power supplies by swinging the cover to the left; then, remove it from the tab on
the other side. Pull it back and off, and store it in a safe place.
3. If you are installing a hot-swap power supply into an empty bay, remove the
power-supply filler panel from the power-supply bay.
Tab
Release latch
Chapter 2. Installing options
29
Advertisement
Table of Contents
