This equipment generates, uses, and can radiate radio 1.1 GENERAL frequency energy and, if not installed and used • Qualified ALTINEX service personnel, or their in accordance with the instruction manual, may authorized representatives must perform all cause harmful...
MULTI-TASKER ABOUT YOUR MT110-101/103 TECHNICAL SPECIFICATIONS MT110-101/103 FEATURES/DESCRIPTION MT110-101/103 GENERAL 8-in 8-out Mono Audio Matrix Inputs Switcher Card (4) 5-pin Terminal Input Connectors Blocks The MT110-101/103 is a Balanced Audio Matrix Outputs Switching Card designed for use with the Multi- (4) 5-pin Terminal Output Connectors Tasker...
MULTI-TASKER INSTALLING YOUR MT110-101/103 OPERATION Step 1. Slide the MT110-101/103 into an available 7.1 RS-232 CONTROL slot in the Multi-Tasker™ Basic Enclosure When used in the Multi-Tasker™ Enclosure, the in order to connect to the bus. Make sure MT110-101/103 has many advanced remote control that the MT110-101/103 card fits into capabilities, which are accessible through standard place.
Page 8
MULTI-TASKER [VERC3]: equivalent to [VERC3U0] Input4 is connected to Output5 and Output5 is disabled 1. [VER] Input5 is connected to Output6 and Output6 is This command receives the software version and disabled card type for the MT110-101/103 card. Input7 is connected to Output7 and Output7 is Command Format: [VERCnUi] disabled Cn = card ID number (n = # from 1 to 19)
Page 9
MULTI-TASKER m -from 0 to 128. executed ( [SW] ). Commands ending in "P" are not executed immediately. The path for outputs on multiple cards or the same card 6.[OSOnCi] can be loaded. This command is set Output offset n - from 0 to 128 Command Format: [ONmCnUiP] 7.
Page 10
MULTI-TASKER output 2 and 3 remain ON. After processing a command, an OK or ER will Turns OFF output 2 and 3. be returned as feedback if "F" is included at [OFF23C5]: 2) If card 5 of unit 3 has output 1, 2, 3, 4, 5, the end of a command string or if the unit ID is 6, 7 and 8 ON: zero.
MULTI-TASKER This command sets path to adjust the individual volume level single card. Command Format: [SELmCn] [–] [–] [–] [–] or [+] [+] [+] [+] m = Input number (m = 1 to 8) n = Card ID number (n = slot # from 1 to 19) + = increases volume.(maximum of 15 levels for audio).
Page 12
If the LED is still blinking red, see Solution 3. Solution: Push the card in all the way. If the LED is still not lit, see Solution 3: Call ALTINEX at (714) 990-2300. Cause 3. B) Cause 2: The MT110-101/103 card and C) Cause 3: Card cage slot has a problem.
8.4 SOUND DISTORTION 9.2 RETURN POLICY A) Cause 1: The source level is above 1V Please refer to Altinex web site for details on return p-p. policy. Solution: Make sure that the source level is 9.3 CONTACT INFORMATION below 1V p-p.
Need help?
Do you have a question about the MULTI-TASKER MT110-101 and is the answer not in the manual?
Questions and answers