Table of Contents
Advertisement
Installation
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 170° to each side direction and 340° on the whole.
• Tilt Base covers total 146° angle(73°to each side).
• Angle range of Rotate Base is the same as that of Pan Base. But One side
range is 195° and another is 145°
2) Methods of adjustment
• The case of wall installation
After mounting the camera on a wall, adjusting the panning angle so that the
camera can face the direction to monitor when tilting.
And then adjust the tilting angle by rotating the tilt base.
Loosen the rotate base hold screw and adjust rotate base for the best
monitoring.
Tighten the rotate base hold screw.
• The case of ceiling installation
After mounting the camera on a ceiling, adjusting the panning angle for better
monitoring area by rotating the pan base.
And then adjust the tilting angle by rotating the tilt base.
Notes
• W hen adjusting the rotating angle, loosen rotate base holding screw as following
Figure A. And then tighten it again.
• W hen adjusting the tilting angle, just grip the tilt base and adjust tilting angle.
• W hen adjusting the panning angle, loosen pan base holding screws as the
following Figure B. And then tighten them again.
• 2 LEDs are paned in case of control Tilt angle(73°) to maximum but it is no
difference of visibility range performance.
10
COLOR IR CAMERA
User's Manual
Rotate Base Holding Screw
Pan Base Holding Screw (Color:Gold)
• I n case of adjusting the tilting, do not take the lens for preventing physical shocks.
Please take the Tilt Base
Adjusting varifocal lens zoom and focus
1) Unlock the zoom(or the focus) handle to release it
2) Adjust the zoom(or the focus) handle by moving it to WIDE(NEAR) or TELE (FAR) position.
3) After adjustment, tighten the zoom(or the focus) handle, taking care that the
adjusted position does not change.
COLOR IR CAMERA
Rotate Base Holding Screw
Focus Handle
Zoom Handle
11
User's Manual
Advertisement
Table of Contents
