Installing The Display - Nds surgical imaging Dome Ex User Manual

Installing the Display

Before you install the display controller, remove any graphics card and its driver from
your system. Also disable any onboard graphics capability on the motherboard.
Install your Dome display with one of the qualified graphics cards shown in the
following table. See the I/O bracket of the graphics card on "Qualified Graphics Cards"
on page 32.
DISPLAY
Dome E2
Dome E2cHB
Dome E3
Dome E3cHB
Dome E3cHB
DisplayPort
‡
Dome E4c
Dome E5
* DisplayPort-to-DVI adapter required.
† DisplayPort-to-DVI adapter required for second Dome Ex display, except Dome E3cHB DisplayPort.
‡ Refer to Dome E4c Display User's Guide for instructions.
Warning
In locations where 240V outlets are used, connect the Dome Ex display only to a
center-tapped, 240V, single-phase supply (for Canada and the United States only).
If you leave the computer turned on, you could get an electric shock and cause damage to
the system components.
Remove the display controller slowly from its package and static-shielding bag to prevent
an electrostatic discharge.
Static electricity can damage the controller. When touching the board or parts of the
motherboard, take these precautions:
• Wear an antistatic wrist strap.
• Discharge your body's static electricity repeatedly by touching the power supply or the
metal surface of the computer chassis.
NVS
*
295
FX 380
QUADRO
†
†
600
2000
†
2000D 4000
Installing the Display | 5