Table of Contents
Advertisement
6 | Dome GX2MP Plus
Installing the Display
Before you install the display controller, remove any existing graphics
card and its driver from your system. Also disable any onboard
graphics capability on the motherboard.
NOTE: The Dome GX2MP Plus display is supported only in digital
mode. Use of DICOM calibration with the Dome CXtra software can
only be supported on the DVI-D interface. Do not use analog mode;
that is, the D-sub interface.
Some NVIDIA boards require a DisplayPort-to-DVI adapter for each
connector port.
Warning
In locations where 240V outlets are used, connect the display to
a center-tapped, 240V, single-phase supply only (for Canada
and the United States).
If you leave the computer turned on, you could suffer electric shock
or cause damage to system components.
Remove the display controller slowly from its package and static-
shielding bag to prevent an electrostatic discharge.
Static electricity can damage the controller. When touching the
board or parts of the motherboard, take these precautions:
• Wear an antistatic wrist strap.
• Discharge your body's static electricity repeatedly by touching the
power supply or the metal surface of the computer chassis.
Advertisement
Table of Contents
