Nds surgical imaging Dome Ex User Manual page 24

Dome E3 Specification
In locations where 240V outlets are used, connect the Dome E3 display to a center-tapped,
240V, single-phase supply only (for Canada and the United States).
Category Characteristic Item
Screen Screen size diagonal
Resolution
Pixel pitch
Pixel arrangement
Active area (mm)
Color supported
Refresh rate
Contrast ratio
Brightness
Pixel rise/fall time
Viewing angle
Interface Digital Video In
Display control - brightness/contrast DDC2B+
Display identification
USB hub
Display status
Input formats Landscape orientation
Portrait orientation
VGA to SXGA
Screen type
Physical Display size (without stand)
Display weight (without stand)
Mounting options
Power Adapter, 8-pin power connector
22 | Dome Ex Display
Specification
528 mm (20.8 in.)
1536 x 2048 pixels (portrait)
2048 x 1536 pixels (landscape)
0.207 mm, 123 ppi
Subpixel vertical stripe
423.9 (H) x 318.0 (V)
256 shades of gray, programmable gamma from
palette of up to 3061 shades
60 Hz
900:1 (typical)
2
1000 cd/m (typical)
35–50 ms
170° (± 85°) horizontal/vertical
DVI Rev. 1.0 digital dual-channel connector
EDID read using DDC2B+
Universal Serial Bus (USB) Rev. 2.0:
1 uplink B port; 2 downlink A ports
Dual-stack tricolor LEDs on back panel
2048 x 1536 (8- and 24-bit per pixel)
1536 x 2048 (8- and 24-bit per pixel)
640 x 480 to 1280 x 1024 pixels displayed in
both landscape and portrait rotations
AMLCD (active-matrix liquid crystal display)
475 mm x 368 mm x 96 mm
(18.7 in. x 14.5 in. x 4.0 in.)
6.35 kg (<15 lb)
Desktop stand with integrated USB (standard);
100-mm VESA mounting (optional)
Ault MW122RA1223F52 or Ault MW122KA1223F52
BridgePower BPM130S12F02 (with power switch)
(CAUTION: Use only the adapter supplied with unit.)