Operational instructions
Final Check
Your treadmill is now assembled. Please make the following final checks:
• Make sure all screws / bolts are tightened.
• Make sure the equipment is on a flat, level surface.
Power Up
1. Plug one end of power cable into the treadmill as shown.
2. Plug the other end into a suitable AC outlet (220-240 volt, 50Hz).
3. Switch the treadmill on using the on/off switch.
4. Attach the safety key to the console.
NOTE: Before you run on the treadmill for the first time, allow the treadmill to run independently
for 10 minutes. Check the running mat is tightened correctly and runs smoothly. If you think the
mat needs adjusting please see "Care & Maintenance" section for more details.
Folding the treadmill
Before folding the treadmill, make sure it is on the lowest
incline setting, then turn off and unplug the treadmill. Lift
the deck slowly with both hands, until it clicks.
Unfolding the treadmill
Release handle
Pull the release handle, then lower the deck to the ground.
To move the treadmill
This treadmill is easy to move around safely. Please
follow the instructions to fold the treadmill before
moving it.
Hold both handlebars and tilt the treadmill until you are
able to use the transportation wheels to move it.
Transportation wheel
Safety Key
The treadmill will only operate when the safety key is in
position - if the safety key is removed while the treadmill
is in operation, it will stop immediately. Before every
workout session please make sure you attach the safety
key to the console and the clip at the other end to your
clothing. When the treadmill is not in use, you should
Safety Key
remove the safety key and store it somewhere safe, out
of the reach of children.
8
www.yorkfitness.com