Troubleshooting - York Aspire 51110 Owner's Manual

Troubleshooting

If you have a problem with your treadmill, before you do anything else please check that
all the cables have been connected correctly. Loose cables are very common and many
problems can be solved by making sure the cables are properly connected.
The following table details the most common problems and how to fix them. If you still have a problem
after going through the troubleshooting guide please call your local YORK distributor for advice.
PROBLEM
TREADMILL WILL NOT START
TREADMILL BELT SLIPPING
TREADMILL NOISY
Console Troubleshooting Guide
ERROR CODE
E01
E07
CAUSE
Not plugged in.
Safety key not attached correctly.
Treadmill circuit breaker tripped.
On/Off switch not turned on.
Auto shut down time out.
Walking belt too loose.
Deck needs lubrication.
Loose hardware.
Motor straining.
Clicking sound - roller knocking.
PROBLEM DESCRIPTION
Wires are damaged or not
connected properly.
No signal received from the speed
sensors for 15 seconds.
Speed sensor is too far from
magnet.
Motor is non-operational or
damaged.
Safety key not attached correctly.
www.yorkfitness.com
CORRECTION
Plug into suitable outlet.
Insert safety key.
Reset circuit breaker.
On/Off switch turn on.
Unplug and re-plug electrical cord.
Tighten walking belt.
Lubricate belt and deck.
Tighten all visible screws, nut, and bolts.
Check mat tension - 3 finger test.
Adjust rear rollers - check the tension.
CORRECTIVE ACTIONS
Verify all wires are connected properly.
If problem persist, contact your local YORK
distributor.
Insert safety key.
15