Bissell 44L6 series User Manual page 10

o
perations
ReadyTools™ (cont)
6. To begin cleaning with attachments, follow
the instructions on pages 7-8 for filling the
2-in-1 water tank.
7. Set the ReadyTools dial to the TOOLS
setting. This will allow spray and suction
from the hose.
8. Attach the cleaning tool to the end of
the hose.
9. Clean by pressing the spray trigger
to spray solution onto the area to be
cleaned. Slowly move the tool back and
forth over the soiled surface. Release
the spray trigger to suction dirty water.
Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from a tap to rinse out the hose.
12. Before wrapping hose onto tool rack, lift
end of hose and stretch out to ensure all
water is cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on pages 8
through 9.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the
dial may need to be cleaned. To clean,
first remove nozzle and locate screw that
holds the diverter assembly in place. With
a Phillips screwdriver, remove the screw
and set aside.
16. Remove diverter assembly; hold under
running water making sure water flows
through and around the dial. Turn the dial
about 10 times clockwise and 10 more
times counter clockwise. This should free
up any debris.
17. Wipe diverter assembly with a soft
cloth and replace back on machine.
Replace nozzle.
18. Return ReadyTools dial to FLOOR
CLEANING setting.
10
w w w . b i s s e l l . c o m
Tip:
To clean with sliding
crevice tool, slide brushes
forward to clean stain, slide
back to suction
7.
11.
Run water through here
15.
Screw
12.
16.