Table of Contents
Advertisement
Table 12
Switch A and Switch B: general default settings
Setting
Bridge Hello Time
Bridge Forward Delay
Bridge Priority
MAC Address Aging Time
Port Priority
Path Cost
Static VLAN Entry
Port VID
Port Trunking
Port Trunking Load Sharing Algorithm
Port Mirroring—Mirror Status
Port Mirroring—Mirror Port
Port Mirroring—Mirror Port Traffic
Direction
Port Mirroring—Monitoring Port
SNMP
SNMP System Name
SNMP System Location
SNMP System Contact
SNMP Community String/Access Right
SNMP Trap Host 1
SNMP Trap Host 1 Community String
SNMP Trap Host 2
SNMP Trap Host 2 Community String
SNMP Authentication Traps
SNMP Link Up/Down Traps
Security IP Network/Mask
TFTP Server IP Address
TFTP Port Number
Firmware Upgrade
Configuration File from TFTP Server
Configuration File to TFTP Server
PING Tool
Trace Route Tools
Serial Port Baud Rate
Value
2 seconds
15 seconds
32768
300 seconds
128
4
Default VLAN (VID = 1)
1 for all ports
Trunk Group 1, Enabled with Port 17
and 18
The algorithm selects the following as forwarding ports for forwarding traffic:
1
For forwarding IP Packets—modulus of XOR of last 3 bits of Source and last 3
bits of Destination IP address
2
For forwarding non-IP packets—modulus of XOR of last 3 bits of Source and
last 3 bits of Destination MAC address
3
For forwarding broadcast, multicast packets, and unknown unicast packets—
the lowest active port number in the trunk group
Disabled
None Selected
None Selected
None Selected
Read/Write
None
None
None
Public = read-only
Private = read/write
0.0.0.0
Public
0.0.0.0
Public
Disabled
Enabled
0.0.0.0/0.0.0.0
0.0.0.0
69
File name = none
File name = none
File name = none
Target address = undefined
Default tries = 5
Target address = undefined
9600
Runtime switching software default settings 40
Advertisement
Table of Contents
