Table of Contents
Advertisement
EtherFast Cable/DSL VPN Router with 4-Port 10/100 Switch
Factory Defaults
The Factory Defaults screen allows you to restore the Router's configuration to its factory default settings.
Restore Factory Defaults. To clear all of the Router's settings and reset them to its factory defaults, click the Yes
radio button.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click
the Cancel Changes button to undo your changes.
Note: Do not restore the factory defaults unless you are having difficulties
with the Router and have exhausted all other troubleshooting measures. Once
the Router is reset, you will have to re-enter all of your configuration settings.
Firmware Upgrade
The Firmware Upgrade screen allows you to upgrade the Router's firmware.
Before upgrading the firmware, download the Router's firmware upgrade file from the Linksys website,
www.linksys.com. Then extract the file.
File Path. In the field provided, enter the name of the extracted firmware upgrade file, or click the Browse
button to find this file.
Upgrade. After you have selected the appropriate file, click the Upgrade button (located at the bottom of the
screen), and follow the on-screen instructions.
Note: If you upgrade the Router's firmware, you may lose its configuration settings.
Chapter 6: Using The Router's Web-based Utility
The Administration tab
Figure 6-29: Administration tab - Factory Defaults
Figure 6-30: Administration tab - Firmware Upgrade
42
Advertisement
Table of Contents
