Pppoe; Ras; Pptp; Figure 5-5: Basic Pppoe Setup - Cisco Linksys BEFVP41 v2 User Manual

EtherFast Cable/DSL VPN Router with 4-Port 10/100 Switch

PPPoE

If your DSL provider says that you are connecting through PPPoE or if you normally enter a user name and
password to access the Internet, perform these steps:
A. Select PPPoE as the Connection Type.
B. Enter the User Name.
C. Enter the Password.
D. Enter the Service Name, if required.
E. Click the Save Settings button to save the settings, or click the Cancel Changes button to clear the settings
and start over.
F. When you are finished, click the Status tab, and then click the Connect button to start the connection.
Proceed to step 5.

RAS

RAS is a service used in Singapore only. If you are using a RAS connection, check with your ISP for the necessary
setup information.
When you are finished with the Setup tab, proceed to step 5.

PPTP

PPTP is a service used in Europe only. If you are using a PPTP connection, check with your ISP for the necessary
setup information.
When you are finished with the Setup tab, proceed to step 5.
Chapter 5: Configuring the Router
PPPoE

Figure 5-5: Basic PPPoE Setup

14