Heart Beat Signal; Figure 5-6: The Registration Url - Cisco Linksys BEFVP41 v2 User Manual

EtherFast Cable/DSL VPN Router with 4-Port 10/100 Switch

Heart Beat Signal

Heart Beat Signal is a service used in Australia only. If you are using a Heart Beat Signal connection, check with
your ISP for the necessary setup information.
A. When finished making your changes on this tab, click the Save Settings button to save this change, or click
the Cancel Changes button to undo your change. For further help on this tab, click the Help button.
B. Click the Status tab, and then click the Connect button. When you are finished, proceed to step 5.
5. If you haven't already done so, click the Apply button and then the Continue button to save your Setup
settings. Close the web browser.
6. Reset the power on your cable or DSL modem.
7. Restart your computers so that they can obtain the Router's new settings.
If you need advanced setting information, please refer to "Chapter 6: Using the Router's Web-based Utility" or the
Linksys support website at support.linksys.com.
Congratulations! You've successfully configured the Router. Test the setup by opening your web browser from
any computer and entering www.linksys.com/registration.
If you are unable to reach our website, you may want to review what you did in this section or refer to "Appendix
A: Troubleshooting."
Proceed to "Chapter 6: Using the Router's Web-based Utility"
for more details and advanced settings information.
Chapter 5: Configuring the Router
Heart Beat Signal

Figure 5-6: The Registration URL

15