Connect To The Internet - Telstra Pre-Paid Quick Manual

4. CONNECT TO THE INTERNET

Make sure Wi-Fi is enabled on your computer or other device, then search for available Wi-Fi networks.
You need to connect to the Wi-Fi network called TPP4G, which is your Telstra Pre-Pay 4G Wi-Fi device.
Enter the password shown on the front display of your Pre-Pay Wi-Fi.
After entering the password you will be connected to the internet automatically (default setting) so you are now ready to browse, work and play with
super fast wireless broadband speeds.
You can connect up to ten different devices to your Wi-Fi router. Repeat the same steps on each device to connect them to your Wi-Fi router.
Most devices will 'remember' the network name and password and will automatically connect whenever the Wi-Fi router is on and in range.
Roaming
The roaming icon indicates you are connected to another network from your service provider. High data charges can apply, depending on your
network sharing agreements.
If travelling overseas you are advised to contact your service provider to determine the lowest cost network sharing available.
Low Power Mode (Standby Mode)
If there is no Wi-Fi device connected to the wireless router it will go into low power mode (standby mode) after 10 minutes (default setting).
• Press the Power key or the WPS key to wake up your device
Connecting an External Antenna (optional)
Using an external antenna may be recommended in areas of lower coverage to improve your router performance.
TS5 termination antennas are available from your retailer. Insert the connector carefully to avoid damage to your router.