Zones Remaining Bypassed After Disarming - First Alert FA1660C User Manual

To use the Group Bypass feature:
1. Enter your security code and press
group number (01-15).
BYPASS 007 FRONT
2.
UPSTAIRS BEDROOM
Typical bypass message
3.

Zones Remaining Bypassed After Disarming

The system provides an option to allow all manually bypassed zones to remain
bypassed upon disarming (security code + OFF) of the partition. This option must be
programmed by your installer. Check with your installer to see if this option has been
enabled.
NOTES:
For each partition in which the option is enabled, the security code + OFF will no
longer unbypass zones. To unbypass ALL zones you must enter your security code + #
+ 64. To unbypass zones INDIVIDUALLY, you must enter your security code + 6 +
zone number.
Any zone that was automatically bypassed by the system will be unbypassed upon
disarming the system (e.g. STAY mode, Auto-STAY, etc.).
Vent zones and zones bypassed by a programmed Auto-Bypass schedule (Tme Driven
Event) are considered "manual bypasses" and will not be unbypassed upon disarming
the system.
Zones that were in a bypassed state at the time a System Shutdown is sent
from the Compass Downloading software will be unbypassed when the
System Shutdown is removed.
Bypassing Protection Zones (cont'd)
DISARMED BYPASS
READY TO ARM
BYPASS
6 then press
In a few moments, all the zones in the group will be
displayed along with the word BYPASS. Wait for
these zones to be displayed before arming. Arming
the system before bypassed zones are displayed
eliminates all bypasses.
Arm the system as usual when the keypad displays
the "ready" to arm message. Bypassed zones are
unprotected and will not cause an alarm when
violated while your system is armed.
✳
then enter the
– 35 –