Mirrored Memory Configuration - HP ProLiant DL380 User Manual

requirements are based on these classifications. A dual-rank FBDIMM is similar to having two single-rank
FBDIMMs on the same module. Although only a single FBDIMM module, a dual-rank FBDIMM acts as two
separate FBDIMMs. The purpose of dual-rank FBDIMMs is to provide the largest capacity FBDIMM for the
current DRAM technology. If the current DRAM technology allows for 2-GB single-rank FBDIMMs, a dual-
rank FBDIMM using the same technology would be 4-GB.
In online spare mode, a single rank of memory acts as the spare memory. For single-rank FBDIMMs, the
entire FBDIMM acts as the spare memory. For a dual-rank FBDIMM, only half of the FBDIMM acts as the
spare memory while the other half is available for operating system and application usage.
If one of the non-spare FBDIMMs receives correctable memory errors at a higher rate than a specific
threshold, the server automatically copies the memory contents of the degraded rank to the online spare
rank. The server then deactivates the failing rank and automatically switches over to the online spare.
Because FBDIMMs that experience a high rate of correctable memory errors also have a higher
probability of receiving an uncorrectable memory error, this configuration reduces the likelihood of
uncorrectable memory errors that would result in server downtime.
Online spare is performed per branch of the memory controller. For a server with both branches
populated, two ranks are used for online spare memory. One branch can fail over to the associated
online spare while the other branch is still protected.
Each branch is made up of two banks:
Branch 0 contains banks A and C
Branch 1 contains banks B and D
Online spare FBDIMM configuration requirements (in addition to general configuration requirements):
When only bank A is being used, it must be fully populated with dual-rank FBDIMMs.
If banks A and C are being used, they must be fully populated.
If installed, bank A and bank C must contain FBDIMMs with identical part numbers.
If installed, bank B and bank D must also contain FBDIMMs with identical part numbers.
In online spare mode, FBDIMMs must be populated as specified in the following table:
Configuration
1*
2
3
* Configuration 1 is only supported if using bank A, populated with dual-rank FBDIMMs.
After installing FBDIMMs, use RBSU to configure the system for online spare memory support
("Configuring online spare

Mirrored memory configuration

Mirroring provides protection against uncorrectable memory errors that would otherwise result in server
downtime.
Mirroring is performed on the branch level. Branch 0 and branch 1 mirror each other.
Each branch maintains a copy of all memory contents. Memory writes go to both branches. Memory
reads come from only one of the two branches (unless an uncorrectable error occurs). If a memory read
on one branch returns incorrect data due to an uncorrectable memory error, the system automatically
retrieves the proper data from the other branch. A branch is not necessarily disabled (thus losing
Branch 0 Branch 0
Bank A Bank C
1A and 3A 2C and 4C
X —
X X
X X
memory" on page 63).
Branch 1 Branch 1
Bank B Bank D
5B and 7B 6D and 8D
— —
— —
X X
Hardware options installation 45