Table of Contents
Advertisement
IMS-9000 User's Manual
System Connection Diagram
Modem
Laptop or Desktop PC
Unpack your IMS9000 and verify that all of the contents listed in the Parts Check List
section are accounted for. If any parts are missing, please contact Delphi Display
Systems at the number listed in the back of this manual for replacement parts.
Location
The IMS9000 is designed to be wall mounted in the back office of the store. Choose a
location that meets the following requirements:
• The front panel indicators are easily visible and can be observed at all times.
• The mounting location is within six (6) feet of an AC power outlet.
• The mounting location is in close proximity to the telephone (modem) line to be
connected to the IMS9000.
Typical Installation
1. Mark the locations of the two (2) mounting screw holes on the wall in the desired
location at exactly 3.50" on center. Refer to the Rear Panel Layout figure below.
2. Drill two pilot holes and install the two #8 screws provided. Allow each screw to
protrude from the wall approximately 1/8" so that it will lock into the rear panel
keyholes of the IMS9000. In locations where installing to drywall, use the supplied
anchors if necessary. To install anchors, drill two ¼" holes and insert the anchors
flush to the wall surface.
Notice: No part of this document may be reproduced, copied or distributed without
written permission from Delphi Display Systems, INC.
Copyright ©2000. [Unpublished Work]. All rights reserved.
IMS9000 Intelligent Modem Switch
PC (optional)
RS232
Serial
Cable
Telephone
Cord
Back Office PC
(Optional)
Phone
Phone
Telephone
Line
Line
Company
Figure 3 - System Connection Diagram
Installation
Delphi
Line Phone
PWR
OCS
POS
RS232 / RS422
I/O Cable
RS232
Serial
Cable
Telephone
Point of Sale Terminal
Cord
Telephone
Delphi
Order Confirmation System
Page 9
Advertisement
Table of Contents
