Push Buttons; Connector Layout; Figure 2 - Connector Layout - Delphi Display Systems IMS-9000 User Manual

IMS-9000 User's Manual
POS Status LED Indicators
LED Indicator
TXD
RXD
RTS
CTS
DTR
DSR
OCS Status LED Indicators
LED Indicator
TXD
RXD
PASS

Push Buttons

There are three (3) push buttons on the front panel of the IMS9000.
RESET
The RESET push button resets the IMS9000 and puts it into its power-up condition.
Any telephone connections are immediately dropped and the unit returns to Automatic
mode of operation (POS connected to the OCS).
MODE
The MODE switch manually cycles through each mode of operation. Each time the
button is pressed, the IMS9000 advances to the next mode until it returns to Automatic
mode.
OCS TEST
The OCS TEST button performs a self-test of the OCS when it is connected. The
results of the self-test are displayed on the PASS LED indicator. Green indicates PASS
and Red indicates FAIL.

Connector Layout

PC (optional)
Notice: No part of this document may be reproduced, copied or distributed without
written permission from Delphi Display Systems, INC.
Copyright ©2000. [Unpublished Work]. All rights reserved.
Function
Transmit Data.
Receive Data.
Request to Send.
Clear to Send.
Data Terminal Ready.
Data Set Ready.
Table 4 - POS Status LEDs
Function
Transmit Data. This LED flashes when data is transmitted to the OCS.
Receive Data. This LED flashes when data is received from the OCS.
OCS Test Status Indicator. GREEN indicates Pass, RED indicates Fail.
Table 5 - OCS Status LEDs
Line Phone

Figure 2 - Connector Layout

PWR
POS
OCS
Page 7