Assembly - Mantis 7262 Operator's & Parts Manual

Assembly

!
WARNING•DANGER
IMPROPER ASSEMBLY OF THIS TILLER
CAN RESULT IN SERIOUS INJURY.
MAKE SURE TO FOLLOW ALL
INSTRUCTIONS CAREFULLY.
IF YOU HAVE ANY QUESTIONS
CONTACT OUR FACTORY AT
1-800-366-6268
OR AN AUTHORIZED
MANTIS DEALER
Your MANTIS Tiller comes partially
assembled. You must install only the
handlebars, the carrying handle, and the
tines. This will take just a few minutes if
you follow the directions.
First, take all items out of the carton.
But do not remove the cardboard from
around the Tiller's base.
The list at the right, shows the parts that
come with your tiller. Check to make sure
you have them.
The bag of hardware is in the plastic bag
containing the Operator/Parts Manual.
To assemble your MANTIS Tiller, you'll
need two 7/16" wrenches. We suggest that
you install all nuts and bolts only "finger
tight" — that is, one-half to one full turn
— until you've completed assembly. The
nuts are self locking, but you must use
a wrench to tighten them completely.
6
Classic 4-Cycle Tiller Operator/Parts Manual
!
39
40
8
53
Quantity Description
1 Upper Handle ssembly
1 Upper Handle Throttle Side ssembly
2 Lower Handles
1 Pair Tiller/Cultivator Tines
1 Engine ssembly (includes Fender
Guard & Worm Gear Transmission)
1 Handle Brace
1 Plastic Carrying Handle
1 Bag of Hardware Containing:
2 Cap Screws
4 Lock Nuts
2 Bolts (3" long)
2 Tine Retaining Pins
2 Handle Clamps
1 Throttle Clips
2 Bolts
2 Knobs
*These numbers are the same numbers shown on the Parts
Layout on page 19.
20,21,55
42
6
1
2
*Key #
2
1
6
39,40
20,21,55
8
42
47
48
49
41
51
13
52
53