Set Ip Address - Eneo GLS-2302H Operating Manual

5.2.2 Set IP Address

You need to set an IP address for the unit if the LAN unit isn't connected to a DHCP server. Otherwise, please follow
the instructions given below:
Set the IP, MASK and GATEWAY. The following is a sample setting.
IP: 9.68..X
MASK: 55.55.55.0
GATEWAY: 0.0.0.0
NOTE: When only one unit of the Video Server is connected to a computer or LAN, you can freely assign
an IP address for the Video Server. For example, there are a range of Video Server IP addresses from
192.168.1.1 to 192.168.1.255. You can pick one for use from the range of the IP. It's not necessary
to set MASK and GATEWAY; leave the settings as default.
When a Video Server is connected to a WAN, you must acquire a unique, permanent IP address and
correctly configure the MASK and GATEWAY settings according to your network architecture.
If you have any questions regarding those settings, please contact a qualified MIS professional or
your ISP.
NOTE: When connecting to a network, each connected Video Server must be assigned a unique IP, which
must be in the same class type as your network address. IP addresses are written as four sets of
numbers separated by periods; for example, 192.168.1.1 Therefore, if the connected network is
identified as Class C, for example, the first three sets of numbers of the Video Server IP address must
be the same as the network address. If the connected network is identified as Class B, the first two
sets of numbers of the Video Server IP address must be the same as the network address. If you have
any questions regarding these settings, please contact a qualified MIS professional or your ISP.