Installation; Connecting With A Camera; Updating System Software - Eneo GLS-2302H Operating Manual

4. Installation

Please follow the instructions and the diagram below to set up the system.
NOTE: The Video Server is linked by its Video Out connection via a BNC connector to a monitor's Video In
connection. If this connection is there, you can see some information on the monitor screen, such as
the Video Server factory default Static IP address (192.168.1.168). But the Video Server Static IP
address can only appear if there is a connection between the Video Server and another device.
If there is no such connection, the Video Server factory default Static IP address will not appear on
the monitor screen.

4.1 Connecting with a Camera

4.2 Updating System Software

If the system software of the Video Server needs to be upgraded, please take the following steps to safely process it.
IMPORTANT: Before carrying out the following procedures, please ensure the SD card is working and the file
of the system firmware is intact
. Create a directory named UPGRADE (upper-case or lower-case letters are no difference) in the SD card if it does
not exist.
Copy the file of UPDATE.BIN to the UPGRADE directory.
.
. If the Video Server is running, please power it off first.
4. Insert the SD CARD into the Video Server.
5. Remove the Ethernet cable from the RJ-45 port and then power on the Video Server.
to camera BNC connector
0
Digital or analog camera