HP xp7010/xp7030 User Manual page 53

Setup functions (continued)
Command Parameters
FWVERS ?
IPADDR Hex IP address, ?
SNET Hex subnet mask, ?
MAC Hex MAC address, ? Used by network module to tell projector the MAC address
SNUM ?
RSET None
Power and status functions
Command Parameters
SHDN None
W or WAKE None
Description
Queries the projector firmware model number and firmware
version. Similar to VERS, but used to verify that a firmware
update image is appropriate for the projector. The
notification takes this form:
*VERS="proj_model:M.mmm"
Used by network module to tell projector the IP address to
display in the help menu.
Used by network module to tell projector the subnet mask to
display in the help menu.
to display in the help menu.
Queries the projector's serial number.
Restores all settings to defaults.
Description
Puts the projector into cool-down state, and later into standby
state. The projector sends a notification when it enters cool-
down state (STAT=3), and another when it enters standby state
(STAT=0). This keyword requires the projector to be in its on
state (STAT=1).
Do not send any requests other than STAT in the time between
the cool-down and standby state notifications. Otherwise,
unexpected results can occur.
Puts the projector into warm-up state, and later into on state.
The projector sends a notification when it enters warm-up state
(STAT=2), and another when it enters the on state (STAT=1).
This keyword requires the projector to be in standby state
(STAT=0).
Do not send any requests other than STAT in the time between
the warm-up and on state notifications. Otherwise, unexpected
results can occur.
Connecting to a room controller 53