Power Ratings (Minimum); Mo' Bass Specifications - SWR Mo' Bass Owner's Manual

MO' BASS SPECIFICATIONS

Note:
All measurements were taken with a line voltage of 120VAC.
All noise specifications are "unweighted."
All voltages and watts are "RMS."
All measurements taken with tone controls set flat, Aural Enhancer at minimum, all effects disengaged.

Power Ratings (minimum)

Bridge/Mono Mode
900 Watts @ 4 Ohms
650 Watts @ 8 Ohms
440 Watts @ 16 Ohms
(minimum load = 4 Ohms)
Stereo Mode (per side)
600 watts @ 2 Ohms
400 watts @ 4 Ohms
250 watts @ 8 Ohms
150 watts @ 16 Ohms
(minimum load = 2 Ohms)
Frequency Response (Power Amplifier):
-3 dB @ 10Hz to 40kHz
Sensitivity (full output under clipping, 8 ohm load, 100 Hz)
Passive Input Jack: 42 millivolts
Active Input Jack: 84 millivolts
Power Amplifier (Effects Return Jack "in"): 6 volts peak-to-peak
Input Impedance
Passive/Active Input: 1 Meg Ohms
Active Input: 47K Ohms
Effects Returns: 27K Ohms
Output Impedance
Effects Sends: 220 Ohms
Tuner Output: 220 Ohms
XLR Balanced Out: 750 Ohms
Signal To Noise Ratio:
-88 dB (<10 millivolts typical)
Equivalent Input Noise:
15 nanovolts per root/hertz
Dimensions (measured from the rack ears back)
19" W x 5 " H x 13" D (the front panel flanges add 1")
Weight: 29 lbs.
D