Table of Contents
Advertisement
4 – Disc operations
1 – Introduction
Repeat playback
The unit can repeat the whole of the disc, the current track
only, or an A–B portion set as described here. Selecting the
repeat mode is only possible using the remote control unit.
NOTE
You can use this mode with Single, Random, or
Program playback modes.
1 The unit should be in playback, standby or stop mode.
Press the
key so that the display shows
REPEAT
(the
REPEAT
Repeat ON
A to B repeat playback
You can set the points between which playback should loop.
1 While playing back, press the
mote control at the point where the loop is to start
(A-point).
The
indicator lights up and
REPEAT
blinks till the second point (B-point) is entered.
2 Press the
key again at the point where the loop
A-B
is to end (B-point).
NOTE
If the A and B points are too close together, A-B loop-
ing is not possible.
Playback jumps back to the first "A-point" and
continues to the second "B-point" and then returns
to the "A-point" again, repeating the loop.
Intro check
You can skip through the first 10 seconds of all the tracks
on a CD to check the contents of the CD.
NOTE
This function is only available from the remote control
unit.
1 When stopped, in the Continuous (normal) mode,
press the
INTRO CHECK
The first 10 seconds of each track on the disc will be
played back.
Auto spacing
This function inserts a gap of about four seconds between
tracks on playback. This can be useful when recording to
tape, so that automatic searching can take place more easily
on tapes recorded from disc (see "Search keys" on page 33).
NOTE
This function is only possible using the remote
control unit.
18
TASCAM CC-222
IV
MK
indicator lights).
key on the re-
A-B
indicator
A-B
key.
To cancel repeat mode, press the
the display shows
Repeat OFF
goes out.
Cancel the A-B repeat mode by pressing the
the
key. Both indicators will go out.
STOP
During playback, if the
A-B
canceled and playback will continue past the B-point.
NOTE
A-B repeat cannot be set when the specified section
spans more than one track, and cannot be used with
MP3 discs.
2 Press the
INTRO CHECK
to stop this playback process.
NOTE
In Single or Random playback modes, with the disc
stopped, pressing the INTRO CHECK key cancels the
mode and returns to Continuous playback mode.
Press the
key when in playback, standby, or
AUTO SPACE
stop mode, the
indicator lights on the right side of
A.SPACE
the display. Pressing the
AUTO SPACE
the mode and returns to normal playback.
The
key also cancels the mode and stops playback.
STOP
key again so that
REPEAT
and the
indicator
REPEAT
key, or
A-B
key is pressed, the loop will be
key again or the
key
STOP
key again cancels
Advertisement
Table of Contents
