Toyota Prius ZVW30 Series Dismantling Manual page 24

6. Check the voltage at the terminals in the
inspection point in the power control unit.
Caution:
Wear insulated gloves.
To prevent serious injury or death, do
not proceed with dismantling of the HV
system until the voltage at the terminals
in the inspection point is 0 V.
Standard voltage: 0 V
Hint:
Set the tester to DC 750 Volts measure the
voltage.
This inspection is performed to verify that it is safe to remove the HV battery.
7. Cut the rear center seatbelt.
8. Remove the rear seat cushion assembly.
20