Toyota Prius ZVW41 Series Dismantling Manual page 24

6. CHECK TERMINAL VOLTAGE
(1) Check voltage at the terminals in inspection
point in the power control unit.
Caution:
Wear insulated gloves.
To prevent serious injury or death, do not
proceed with dismantling of the HV system
until the voltage at the terminals in the
inspection point is 0 V.
Standard voltage: 0 V
Hint:
Set the tester to DC 750 Volts measure the
voltage.
This inspection is performed to verify that it is safe to remove the HV battery.
7. REMOVE REAR NO. 1 FLOOR BOARD
(1) Remove the bolt.
(2) Disengage the 3 claws, fastener and 4 guides
and remove the rear No. 1 floor board.
8. REMOVE REAR SEAT ASSEMBLY RH
(1) Lift up the seat track adjusting handle and
move the seat to the rearmost position.
(2) Disengage the 2 claws and remove the front
outer seat track bracket cover.
20