Whynter RPD-501WP Instruction Manual page 9

PARTS AND CONTROLS
Continuous Indicator Light
To run the unit in continuous mode, press the Down button until the display reads 35%RH. Then press the Down
button again until the display reads "CO" to initiate continuous operation and the Continuous indicator light will illumi-
nate. To stop continuous operation, press the Up button and set the desired RH percentage value to resume normal
operation.
Display
The display screen shows a number of different indications depending on the selection function.

Shows the set % relative humidity level from 35%RH to 85%RH.

Shows Auto Start and Auto Stop time from 0.0 hour to 24 hours.

After the option settings are completed, the display shows the approximate room humidity level in a range of
30%RH (Relative Humidity) to 90%RH .
AS - Humidity Sensor Error
ES - Temperature Sensor
Error
P2 - Drain Bucket Full
EC - Unit Malfunction
E3 - Unit Malfunction
Eb - Drain Bucket Error
Auto Restart
In the event of a power outage, appliance restarts at the previously set function mode and settings when power is
restored (not applicable to Timer Function).
Error Codes and Protection Code
Unplug the unit and plug it back in.
Unplug the unit and plug it back in.
Empty the drain bucket.
Please make sure float moves freely and is not stuck .
Please make sure whether the environment temperature is
between 41°F (5°C), and 96°F (35°C).
Unplug the unit and plug it back in.
Drain bucket is removed or not positioned correctly. Make
sure that the drain bucket is properly installed and the in
right position.
9