1. Connecting other units to your TV
Caution. Before connecting:
• Make sure to disconnect the appliance from the power
supply in order to avoid any potential damage from
occurring.
• Make sure to establish the required connection.
• Make sure that connections are properly and correctly
attached before connecting the appliances to the power
supply.
Connect with Satellite receiver as shown below.
Select the TV-Program at the satellite receiver.
To do this, use the remote control of the satellite
receiver. You cannot store the same station once again
additionally in LCD-Monitor which already stored in
satellite receiver.
Satellite antenna
Satellite
receiver
DEC
Decoder
Note:
S-Video signals can be played back through the AV2 input (see page 57).
2. Connecting a DVD player
TV (Back side view)
(SCART cable, not supplied)
51Z0101A_ENG.indd 55
51Z0101A_ENG.indd 55
Connection to other equipment
Antenna
Video recorder
VCR
TV
(All illustrated SCART cables and antenna cables are not supplied)
DVD Player
TV (Back side view)
AV2
R
TV (Back side view)
ANT
AV1
DVD player
To ensure optimum picture quality,
select RGB for the DVD player's output
signal (see Owner's manual of the DVD
player). AV1 SCART is compatible with
RGB signal. Select AV1 input mode to
view (see page 11).
55
9/9/08 3:14:14 PM
9/9/08 3:14:14 PM