H3C S5120-EI Series Configuration Manual page 18

[SwitchC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
Configure the hosts.
3.
The default gateways for hosts A, B and C are 1.1.2.3, 1.1.6.1 and 1.1.3.1, respectively. The configuration
procedure is omitted.
Display the configuration.
4.
Display the IP routing table of Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destinations : 7
Destination/Mask
0.0.0.0/0
1.1.2.0/24
1.1.2.3/32
1.1.4.0/30
1.1.4.1/32
127.0.0.0/8
127.0.0.1/32
Display the IP routing table of Switch B.
[SwitchB] display ip routing-table
Routing Tables: Public
Destinations : 10
Destination/Mask
1.1.2.0/24
1.1.3.0/24
1.1.4.0/30
1.1.4.2/32
1.1.5.4/30
1.1.5.5/32
127.0.0.0/8
127.0.0.1/32
1.1.6.0/24
1.1.6.1/32
Use the ping command on Host B to check reachability to Host A, assuming Windows XP runs on the
two hosts.
C:\Documents and Settings\Administrator>ping 1.1.2.2
Pinging 1.1.2.2 with 32 bytes of data:
Reply from 1.1.2.2: bytes=32 time=1ms TTL=255
Reply from 1.1.2.2: bytes=32 time=1ms TTL=255
Reply from 1.1.2.2: bytes=32 time=1ms TTL=255
Routes : 7
Proto Pre Cost
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Routes : 10
Proto Pre Cost
Static 60 0
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
18
NextHop Interface
1.1.4.2 Vlan500
1.1.2.3 Vlan300
127.0.0.1 InLoop0
1.1.4.1 Vlan500
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
NextHop Interface
1.1.4.1 Vlan500
1.1.5.6 Vlan600
1.1.4.2 Vlan500
127.0.0.1 InLoop0
1.1.5.5 Vlan600
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
1.1.6.1 Vlan100
127.0.0.1 InLoop0