Grizzly G0632 Owner's Manual page 36

tool rest
11. position the tool rest approximately
from the workpiece and approximately
above the workpiece center line (see figure
45).
Workpiece
1
⁄ "
4
Distances
1 ⁄ "
8
Tool Rest
figure 45. tool rest position relative to
workpiece.
12. Before beginning lathe operation, rotate the
workpiece by hand to ensure that there is
safe clearance on all sides.
Keep the lathe tool resting on the tool
rest the ENTIRE time that it is in contact
with workpiece or when preparing to make
contact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands with the workpiece.
failure to heed this warning could result in
serious personal injury.
-34-
Spindle Turning Safety Tips:
⁄ " away
1
4
1 ⁄ "
8
•
•
Center Line
•
•
•
Damage to your eyes and lungs could result
from using this machine without proper pro-
tective gear. Always wear a face shield and
respirator when operating this machine.
When turning the lathe ON, stand away from
the path of the spinning workpiece until the
lathe reaches full speed and you can verify
that the lathe will not throw the workpiece.
use the slowest speed when starting or stop-
ping the lathe.
select the right speed for the size of workpiece
that you are turning:
—use the slower speeds for large workpieces
(diameters of 4" and over) and for rough
cutting.
—use the middle range speeds for workpiece
diameters of 2–4".
—use the faster speeds for workpieces under
2".
Keep the turning tool on the tool rest the
entire time that it is in contact with the
workpiece.
Learn the correct techniques for each tool
you will use. if you are unsure about how to
use the lathe tools, read books or magazines
about lathe techniques and seek training
from experienced and knowledgeable lathe
users.
Model G0632 (Mfg. 4/12+)