Table of Contents
Advertisement
3-5-1. The knee support
The knee support holds the knees in an extended posture and prevents you slipping out the
power wheelchair while standing up.
Attach the two triangular form of the knee lock
support to the double-head screws on either side of
the wheelchair.（Fig-20）
Center the knee support in front of each knee using
the Velour fasteners, then pull it until it is sitting
firmly in place, just below (not right on) the knee cap
and not too tight. （Fig-21）
3-5-2. The safety belt（Fig-22）
● The safety belt holds the waist in place.
● Make sure that the safety belt is secure on the
backrest of velour fasten.
● Close the catch on the safety belt and pull it and not
too tight.
● To release the safety belt. Simply press the red
button in the center of the catch.
● To slacken, hold the catch at a right angle to the belt
and pull.
3-5-3. Adjusting the cheat belt（Fig-23 ~ 25）
● Make sure that the chest belt is secure on the backrest of velour fastening.
● The chest belt is holding the upper body (chest in place).
20
21
22
Advertisement
Table of Contents
