Logger And Gps Module - Triadis Engineering Glide Computer and Navigation System Owner's Manual

Com A Port : COM3
Com A Speed : 38400
Com B Device : Vega
Com B Port : COM1
Com B Speed : 38400
Com A Device : Vega
Com A Port : COM3
Com A Speed : 38400
Com B Device : Generic
Com B Port : COM1
Com B Speed : 38400

2.5 Logger and GPS module

Recommended serial settings in XCSoar for Altair Standard and
Vega installations are to use Vega/FLARM as the primary data
source:
XCSoar has a non-approved IGC flight logger. This is referred to
as the 'software logger'. Altair Pro also has an internal hardware
IGC flight logger, referred to here as the 'hardware logger'.
The hardware and software loggers can be enabled or disabled
from the Altair logger dialog activated by XCSoar's menu:
CONFIG
Declarations are made through XCSoar's task editor dialog. If a
USB memory stick is inserted in the USB host slot, the logger files
can then be transferred to the USB memory stick.
Communication between XCSoar and Altair's hardware logger
and GPS source requires the primary or secondary com port to
be set to the following settings:
Port : COM3
Baud rate : 38400
Device : Altair logger
Logger Record
16