Installing Realsecure Desktop Protector - Internet Security Systems RealSecure User Manual

Chapter 3: Setting Up RealSecure Desktop Protector

Installing RealSecure Desktop Protector

Introduction
Local or remote
installation
Manual ICEcap
configuration
Prerequisites
Procedure
22
This topic gives instructions for installing Desktop Protector.
You can install RealSecure Desktop Protector locally at your agent computer or remotely
from RealSecure ICEcap Manager. In most cases, you should distribute Desktop Protector
to network systems from ICEcap Manager. This allows centralized control of
configuration. However, in some cases it may be quicker to install an agent manually.
For information about installing remotely with RealSecure ICEcap Manager, see the
RealSecure ICEcap Manager User Guide.
When Desktop Protector is installed directly on an agent computer, you must manually
configure the ICEcap settings. When Desktop Protector reports to ICEcap Manager, any
configuration and protection settings attributed to the agent's account and group are
distributed to the agent.
Manual installations of RealSecure Desktop Protector always include the local user
Note:
interface. Only ICEcap Manager can create and distribute agents without the local user
interface, known as "silent" agents. For information about installing silent agents, see the
RealSecure ICEcap Manager User Guide.
Before you install RealSecure Desktop Protector, you must do the following:
Scan your system for viruses.
G
Disable the real-time scanning function of any anti-virus detection software on your
G
system to avoid unwanted interactions during the installation.
To install RealSecure Desktop Protector, follow these steps:
4. Are you installing Desktop Protector from the CD?
If yes, go to Step 5.
I
If no, locate the directory to which you downloaded Desktop Protector, and then go
I
to Step 6.
If you have lost your original copy of the software, you can download a new copy
from the Internet Security Systems Web site at
5. Insert the CD in the CD-ROM drive.
6. Double-click RSDPSetup.exe .
7. In the Install Wizard, click Next.
If the setup program detects an existing version of Desktop Protector, the program
prompts you to uninstall or upgrade the existing version.
To update Desktop Protector, click Next.
I
To remove Desktop Protector from your hard drive, follow the instructions in
I
"Uninstalling Desktop Protector" on page 28.
.
www.iss.net