Learning Keys; Learning Tips - Acoustic Research ARR1540 User Manual

Learning Keys

Learning Tips

Before transferring commands from your original remote to the ARR1540, check out these useful tips on Learning.
1. Make sure you are using fresh batteries in both the ARR1540 and your original remote(s).
2. Point the top of the original remote at the bottom of the ARR1540 so the IR LED on the original
remote is in line with the ARR1540's Learn sensor.
3. The distance between the two remotes should be approximately 2-3 inches.
4. To ensure that your units are compatible and to increase your familiarity with the Learning
process, you may want to experiment by learning two or three keys initially. Then, clear all learned
keys before learning all the desired functions from your original remote (see page 20).
5. Incandescent or low-energy light can cause interference with the infrared transmissions between
the remotes (how the remotes communicate to each other). When using the Learning function,
keep the remotes at least three feet away from such light sources.
6. When learning a key, do not release the key on your original remote until Learning Success appears on the touchscreen, which takes approximately
2-3 seconds. Until this occurs, Learning New Key... appears.
7. If there is a problem during the Learning process, Learning Error appears.
8. All Learned keys are saved automatically.
9. When the memory is full, Learning Memory Full appears and the indicator light fl ashes for two seconds. It isn't possible to learn any additional keys
without fi rst clearing all learning memory (see page 20).
Chapter 2
Chapter 2: Programming Chapter 2: Programming
Learn sensor
17