Optional Accessories; Type Of Cut - DeWalt DW713 Instruction Manual

Optional Accessories

The following accessories, designed for your saw, may be helpful. In some cases, other
locally obtained work supports, length stops, clamps, etc., may be more appropriate. Use
care in selecting and using accessories.
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user assembled.
Your saw table is designed to accept two work supports; one on each side.
Adjustable Length Stop: DW7051
Requires the use of one work support. It is used to make repetitive cuts of the same
length from 0 to 42" (1.06 m).
Clamp: DW7082
Used for firmly clamping workpiece to the saw fence for precision cutting.
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Laser Guide System: DW7187
Powered by the saw, the bright laser line delivers enhanced visibility in low and high
light locations. Easy to install.
Miter Saw Replacement Kerf Plate: DW7055
This durable plastic uncut plate limits blade tear out.
SAW BLADES: ALWAYS USE 10" (254 mm) SAW BLADES WITH 5/8" (16 mm) ARBOR
HOLES. SPEED RATING MUST BE AT LEAST 5500 RPM. Never use a smaller diam-
eter blade. It will not be guarded properly. Use crosscut blades only! Do not use blades
designed for ripping, combination blades or blades with hook angles in excess of 5˚.
D WALT BLADE NO. OF
E
BLADE DESC.
RANGE TEETH
Series 20 Thin Kerf
40
Construction Yellow Rim Coating
Series 20 Thin Kerf
60 Yellow Rim Coating Fine Trim Molding
Construction
Laser Cut Body
Series 40
40 Large Carbide
Woodworking
Teeth
Laser Cut Body
Series 40
60 Large Carbide
Woodworking
Teeth
Laser Cut Body
Series 40
80 Large Carbide
Woodworking
Teeth
Laser Cut Body
Series 40 Large Carbide
80
Woodworking Teeth, Special
Tooth Geometry
Laser Cut Body
Series 40
60 Special Tooth
Woodworking
Geometry
Laser Cut Body
Series 40
80 Special Tooth
Woodworking
Geometry
APPLICATION

TYPE OF CUT

Gen. Purpose
Smooth,
(Trim, Decking,
Splinter Free
Framing)
Very Smooth,
Splinter Free
Gen. Purpose
Smooth, Splinter
(Trim, Decking,
Free
Framing)
Fine Trim, Very Smooth,
Molding Splinter Free
Fine Trim Molding
Decorative Ultra Smooth,
Hardwood & Splinter Free
Plywood
Melamines, Ultra Smooth
Veneers, Chip/Splinter
Laminates Free
Plastics and other
Very Smooth
solid surface
Chip Free
materials
Non-ferrous
metals (aluminum, Very Smooth
copper, brass, Burr Free
etc.)
4
DW7080
LOCKNUTS
END PLATE
DW7051
TOP HOLE
(USE IF ON
LEFT SIDE)
KNOBS
BOTTOM HOLE
(USE IF ON
RIGHT SIDE)
BRACKET
DW7082
DW7084
DW7187