Bench Mounting; Important Safety Instructions; Removing The Blade - DeWalt DW713 Instruction Manual

ACCESSORIES
Recommended accessories for use with your tool are available for purchase from your local
dealer or authorized service center.
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous. To
reduce the risk of injury, only D WALT, recommended accessories should be used with
E
this product.

Bench Mounting

Holes are provided in all four feet to facilitate bench mounting, as shown in Figure 2. (Two
different sized holes are provided to accommodate different sizes of screws. Use either
hole, it is not necessary to use both.) Always mount your saw firmly to prevent movement.
To enhance the tool's portability, it can be mounted to a piece of 1/2" (12.7 mm) or thicker
plywood which can then be clamped to your work support or moved to other job sites and
reclamped.
NOTE: If you elect to mount your saw to a piece of plywood, make sure that the mounting
screws don't protrude from the bottom of the wood. The plywood must sit flush on the work
support. When clamping the saw to any work surface, clamp only on the clamping bosses
where the mounting screw holes are located. Clamping at any other point will surely inter-
fere with the proper operation of the saw.
FIG. 2
LEFT SIDE FENCE
CLAMPING KNOB
BENCH
MOUNTING
HOLES
WRENCH
HOLES FOR
EXTENSION KIT
Changing or Installing a New Saw Blade (Fig. 5, 6)
WARNING: Turn off tool and disconnect from power source before attempting to
WALT, have not been
E
move it, changing accessories or making any adjustments accept as written in laser
adjustment instructions.
CAUTION:
• Never depress the spindle lock button while the blade is under power or coasting.
• Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product

Removing the Blade

1. Unplug the saw.
2. Raise the arm to the upper position and raise the lower guard as far as possible.
3. Loosen, but do not remove guard bracket screw until the bracket can be raised far
4. Depress the spindle lock button (Fig. 3) while carefully rotating the saw blade by hand
OPERATING
HANDLE
GUARD
RIGHT SIDE
FENCE
TABLE
MITER LOCK
LEVER
MITER SCALE
BASE
5

IMPORTANT SAFETY INSTRUCTIONS

with this miter saw.
enough to access the blade screw. Lower guard will remain raised due to the position
of the guard bracket screw.
until the lock engages.
FIG. 3
MOTOR
END CAP
SPINDLE LOCK
BUTTON
MOTOR
HOUSING
LEFT SIDE
FENCE
MITER
MITER
DETENT
SCALE
MITER
DETENT
OVER RIDE
INDENTATION
TRIGGER
SWITCH
CARRYING
HANDLE
DUST
SPOUT
BEVEL CLAMP
KNOB
BEVEL
HAND
SCALE