Transmitter Programming - Code Alarm ca 1051 Installation Manual

Feature Bank 1 - 3 Chirps

Transmitter Programming

Refer to transmitter programming.
Feature Bank 2 - 4 Chirps
Security Control
1 Silent Choice
2 Passive Locks
3 Passive Arming
4 Anti-Hijack Mode
Feature Bank 4 - Shock Sensor Adjustment
1. Enter Feature Bank 4
2. Press and release
3. Use
each press.
4. Press
touch setting, the system will give 2 long chirps to confirm.
5. Use or
6. Press and release
programming and give 1 long chirp to confirm. This step must be
completed to properly program the shock senor.
14
1 LED Flash
ON
Active
Active
OFF
to select full trigger.
or to adjust the settings. The system will give short chirps upon
+ for 2 seconds to lock in the change and advance to the lite
to adjust the settings.
+
2 LED Flash
OFF
Passive
Passive
ON
to lock in the change, the system will exit
ca1051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
3 LED Flash 4 LED Flash 5 LED Flash